Item | Unusual phenomenon explanation | Cause and disposal |
1 | The knife jaw over heat | 1.whether the time of boot-strap is too long or not |
2.whether the density of foam is too big or not | ||
3.Adjust the knife jaw, the blade on the position of The outside of knife jaw 10-6mm. | ||
4.replace the knife jaw when necessary | ||
2 | The grinding motor heavy Shake | 1.whether the round of the grinding wheel is of equilibrium or not |
2.Whether the axis of the grinding motor is bent or of transmutation or not | ||
3.replace the motor when necessary | ||
3 | The cutting knife make big noise | 1.much dirt on the wheel – clean the dust with abrasive cloth |
2.the tension device over lax – tighten the knife | ||
4 | The asymmetry of cutting thickness | 1.check that whether the thickness setting and the gyro graph are normal or not |
2.the knife installing position is inexact- examine the horizontality of the knife | ||
3.the angle between knife and level is not right—cutting thickness2.5-10mm,the angle about0.5 °- 2.5 °, above10-150mm, the angle less than -1 °- 1° | ||
1. Inexact cutting—examine the exact of the cutting, select automatic, make it moving without loading Check that whether when cutting the ruler beside slip lid moving correctly or not |
